The best way to make small changes is to do something like:
Code: Select all
-rotate_fixture 26
-rotate_fixture -25
Code: Select all
-move_fixture 0, 0.26
-move_fixture 0, -0.25
-move_fixture directions
On the X axis, negative values will move fixtures west, and positive values will move fixtures east.
On the Y axis, negative values will move fixtures south (use the compass to orient yourself) and positive values will move fixtures north.
So...
Code: Select all
-move_fixture -0.25, 0.37
If you are not moving a fixture along the Y axis, you may shorten the command to:
Code: Select all
-move_fixture 0.25